PDA

View Full Version : Opel Astra J 1.3CDTi edc17c19 need help with dpf off



mobiletehnik
5th October, 2019, 10:21 AM
Opel Astra J 1.3CDTi 2010MY
ecu is Bosch edc17c19

read in boot mode with galleto
make dpf off and egr off
disconected all dpf sensors,dpf reset
write mod file (dpf off and egr off)
cars starts ok but in ecu fault code B0000 vehicle speed information and engine in limp mode
with orginal file all ok

pls can someone help

pike
5th October, 2019, 11:20 AM
Hi,

you disconnect EGR valve too?

mobiletehnik
5th October, 2019, 12:18 PM
Hi,

you disconnect EGR valve too?
no,egr still connected

pike
5th October, 2019, 04:50 PM
you need working solution.

mobiletehnik
5th October, 2019, 05:53 PM
you need working solution.

can you help me?
if you can give me your email or viber

pike
5th October, 2019, 06:19 PM
The following errors occurred with your submission



mobiletehnik has exceeded their stored private messages quota and cannot accept further messages until they clear some space.

tothzsolt
6th October, 2019, 07:19 AM
B0000 Vehicle Speed Information Circuit Invalid Data
.........Vehicle Speed Information Circuit Not Plausible

tothzsolt
6th October, 2019, 07:22 AM
DTC B0000 Diagnostic Instructions



Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.







Review Strategy Based Diagnosis for an overview of the diagnostic approach.







Diagnostic Procedure Instructions provides an overview of each diagnostic category.



DTC Descriptor

DTC B0000 5A: Vehicle Speed Information Circuit Not Plausible


Diagnostic Fault Information





Circuit



Short to Ground



Open/High Resistance



Short to Voltage



Signal Performance





Vehicle Speed Signal



B0000 5A



B0000 5A



B0000 5A



B0000 5A










Circuit/System Description The radio receives a vehicle speed signal from the electronic brake control module in order to correlate actual vehicle speed to the movement of the vehicle calculated by the navigation system and reported serial data.
Conditions for Running the DTC



Radio ON.







Battery voltage must be between 9-16 V.



Conditions for Setting the DTC



Vehicle speed from serial data is more than 5 km/h (3 mph) and vehicle speed pulse from the electronic brake control module is 0 km/h (0 mph).






Vehicle speed calculated from the navigation processing software is more than 36 km/h (22 mph) and vehicle speed pulse from the electronic brake control module is 0 km/h (0 mph) for 10 seconds continuously.