BMW M3 E36 mss50.1 5WK9026 1406611 immo off

[Royro]

Hello.

Please, ineed make inmo off in this ecu is for swap in a race car.

Siemens 5WK9026 DME MSS 50.1

This is my file of right 28F200 read with programmer.

Thanks in advance!

[ecufix]

Here you go,regards

[Royro]

Thanks.

Is not MSS50, my ecu is MSS50.1

[Royro]

Here you go,regards

Thanks.

Is not MSS50, my ecu is MSS50.1

[Royro]

Hello.

immo is in left or right side??, can you send me photo of the correct chip??.

Thanks.

[Lambda1]

read partial via tool is enough. Send i will delete immo iun your file.
its easy going.

[Royro]

read partial via tool is enough. Send i will delete immo iun your file.
its easy going.

Not have the car here, can i read without the car??

[Royro]

This pinout is ok??

88: K-Line

28: Ground

26, 54, 56, 60: Positive

[Lambda1]

sure can be read on bench. pinout look at internet.
for easiest way read partial.
kess read big endian... master and slave, also possible but need swap...
So if you gone this way you also can use your desolde readout :D

[Royro]

Pinout is ok.

This is my file read with kess

[Lambda1]

here you go.

[easytech]

If Lambda's file won't work, this should be it,

[Lambda1]

Mine solutions is personally developed and tested by me :).
He got solutions in slave and partial + advices :), so if dont work isnt immo delete problem.

[easytech]

That could also be the problem, but in the V4.16 software the immo bit isn't active anymore, so a bypass in the immo soft routine is the solution.
No hard feelings....

[Lambda1]

I know. Partial arent recommended for him because he is on kess clone...
He got all he need. We will see his answer :9

[stueyBMW]

Lambda1, you can do immo off in MSS50.1 by partial? Could you please remove immo in my partial read, MSS50.1 5WK9026 1406611?


Mine solutions is personally developed and tested by me :).
He got solutions in slave and partial + advices :), so if dont work isnt immo delete problem.

[Lambda1]

Sure but not if you be here since 5 years and 2 posts...