Automatic gearbox problem after using CAN Filter Gecko Mercedes W212 year 12/2014

[daten]

Hi
We have problem after installing Can Filter Gecko en EIS FAB4 Mercedes w212.
The vehicle stopped starting. According to the diagnosis there is a problem with the automatic gearbox is unconfigured and needs to be programmed. After removing the EIS filter and leaving the vehicle without a battery for a few minutes, the vehicle starts but does not change gears.
Has anyone had a similar or equal experience?


Thanks

[honingkoning]

Make it ori and see what happens

[daten]

Thanks for your answer.
We have left everything in its original state but the car does not start anymore.

[brend]

663392
I don't think the problem was created by the Gecko filter .I think you've done something wrong.


Thanks for your answer.
We have left everything in its original state but the car does not start anymore.

[daten]

Thanks for your answer.
Possibly something has been done wrong, but only work on dash and EZS (EIS) other components were not touched
Attached image of the connected EZS

[sagie1zn]

what does diag test say

[sagie1zn]

what does diag test say on other modules

[daten]

the DTCs in engine ECU are communication with the transmission and the gear shift selector lever

U010187- Communication with control unit " Transmission" has a malfunction. The message is missing
U010387- Communication whit te electronic selector lever module has a malfunction.

[sagie1zn]

do you have communication with cluster with diag tool

[daten]

do you have communication with cluster with diag tool

Yes. With the only module that I can't communicate is the gearbox. Warning is shown with red letters that must be programmed.

[sagie1zn]

your ezs black wire seems to be soldered in the wrong position, according to my diagram

[daten]

your ezs black wire seems to be soldered in the wrong position, according to my diagram


Please can you upload your diagram

[sagie1zn]

will upload when i have my pc later. either way it is back to ori so does not matter for now. i think you need to recheck the component you removed to install the gecko. check soldering and check for solder that can cause shorts. i did hilux mssop and all was good except it read incorrect km. i check with magnifying glass and saw solder shorting two pins