towy12
2nd November, 2019, 01:46 PM
Hi.
So i want to put a permanent cable on the bdm pads but i need some tips and help.
The ecu is a edc16c39 if that makes a difference.
Does anyone have or know of a guide of things one have to think about.
Like power, if the ecu sits in the car it will be powered through that connector. Will that make a difference when flashing over bdm?
I have a cable to power the ktag via the car battery so that there isnt any difference in that regards.
Also how would i go about when soldering the ribbon to the pads.
Hope my rambling makes some kind of sense.
Thanks for your time
So i want to put a permanent cable on the bdm pads but i need some tips and help.
The ecu is a edc16c39 if that makes a difference.
Does anyone have or know of a guide of things one have to think about.
Like power, if the ecu sits in the car it will be powered through that connector. Will that make a difference when flashing over bdm?
I have a cable to power the ktag via the car battery so that there isnt any difference in that regards.
Also how would i go about when soldering the ribbon to the pads.
Hope my rambling makes some kind of sense.
Thanks for your time