PDA

View Full Version : FRM3R PL2 help (A8BC,9CA9,A8BA,A8B7,A8AC,9CAA,9CBB,A8BB,A8AD,9CB5 ,A8B9,A8C3,A8B6,A8B2


soxten
8th November, 2019, 08:40 AM
I have a FRm3R PL2 here wit many codes....
A8BC,9CA9,A8BA,A8B7,A8AC,9CAA,9CBB,A8BB,A8AD,9CB5, A8B9,A8C3,A8B6,A8B2
I have read all Eeprom and flash files and I have info and correct config.
Is my FRM3R unit broken or is it sowftware problem?

6135682706401
61356827064
6827064
vanos batam
8th November, 2019, 09:00 AM
I have a FRm3R PL2 here wit many codes....
A8BC,9CA9,A8BA,A8B7,A8AC,9CAA,9CBB,A8BB,A8AD,9CB5, A8B9,A8C3,A8B6,A8B2
I have read all Eeprom and flash files and I have info and correct config.
Is my FRM3R unit broken or is it sowftware problem?

6135682706401
61356827064
6827064


try this eep fixed
soxten
8th November, 2019, 09:54 AM
Big thx I try!
soxten
11th November, 2019, 01:13 PM
There is no change in your Eeprom_FIX file.
?
urametz
11th November, 2019, 08:13 PM
There is no change in your Eeprom_FIX file.
?
Try my recovery option.good luck.
tomvleeuwen
12th November, 2019, 07:33 PM
Your partition table is not broken so there is no point in trying to recover the EEE from the D-flash. At best it is identical to the original EEE.

Your best bet is to code the FRM3 with NCS Expert, or maybe someting like Autologic or Autel and maybe you need to reset the short circuit counters? (I don't know the DTC's by hard, obviously)

Alternatively, you can try writing the attached file. The attached file that corresponds with your P-flash (6827064) seems incorrectly coded but it's the only one I have, so if that does not work you can try 9249086 but you'll have to write both P-flash and eee since it is different firmware (same hardware revision).