View Full Version : Iveco daily 2.3 2019
looly
10th November, 2019, 07:03 PM
Hi
Does anyone know which ecu type would likely be in one of these pls? I've had an enquiry about setting a speed limit on one but customer doesn't want the ecu to be opened.
Thanks :)
jurebv
10th November, 2019, 07:26 PM
Bosch EDC17C69
looly
10th November, 2019, 07:39 PM
Bosch EDC17C69
Thanks. Do you know if there is any tool which can program this via OBD or if not possible then any tool able to program over pins? Thanks
jurebv
10th November, 2019, 07:58 PM
flex, kess, ktag
looly
10th November, 2019, 08:17 PM
flex, kess, ktag
Thanks. Kess programming is with genuine tool only I guess (read & write). I did read somewhere that kess clone can only write so virtual file required.
jurebv
10th November, 2019, 08:24 PM
2019 vehicle + clone tool = not a good idea
looly
11th November, 2019, 12:39 AM
I agree, not sure if org kess can read this ecu or if it's also write only.
greyg
11th November, 2019, 11:37 AM
Org Ktag "service mode" - no need to open the case. It has been working correctly for a week with edc17c69 from Iveco. Previously there were problems with the identification of the SW. In the description there is a photo of another EDC.
eculevel
11th November, 2019, 03:18 PM
with genuine tools you do it without opening, from pinout
looly
11th November, 2019, 08:23 PM
with genuine tools you do it without opening, from pinout
Thanks, but no org tools to do it via OBD?
SpecZ
12th November, 2019, 12:23 AM
No, only by bench!
Br.
Michael
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.