BOSCH VP44 injection pump how to code IMMO

[Bogdan235]

Hello,

I just changed my injection pump from my Audi a4 b7 2.5 BDG 2006
I read the ECU EEPROM for login (05758) but when i try to log to engine that code is not accepted, any solution?
I added the same injection pump (reference).

[rafal]

post here what you readed............

[Bogdan235]

attached
https://www.dropbox.com/s/x7cu5n74my91fds/8E0920931L__0110_KOMBI_WFS_3_____H12_n__WAUZZZ8E26 A027413_AUX6Z0E0001155_.7z?dl=0

[Volker]

I think you have to read EEPROM from ecu....not Dash

The dump is from VAG DashCAN?

[Bogdan235]

Yes, is from dash scan

[Bogdan235]

I think that i need login pin from the donnor car for log in on motor and at adaptation ch50 to add my pin and addapt... but i don't have donnor car pin...

[salkapone]

Try make immo off in ECU ....

[Shmortz]

immo off must be done in flash and eeprom

[tiguan]

Hello,

I just changed my injection pump from my Audi a4 b7 2.5 BDG 2006
I read the ECU EEPROM for login (05758) but when i try to log to engine that code is not accepted, any solution?
I added the same injection pump (reference).


did you try this procedure details

http://wiki.ross-tech.com/wiki/index.php/Immobilizer_III_Injection_Pump_Swapping

[rafal]

Procedure is ok but we do not know about pin...is it correct or not. User need read ecu and post here dump.

[Bogdan235]

Yes, i used that procedure, to do that you need donnor car pin and my car pin.
Problem is that for login in Motor i need donnor car pin (i don't have it) and my pin to addapt in channel 50. It is any possibility to find donnor car pin without old car? Directly from injection pump? I don't want to do immo of....

[rafal]

No. You need only pin from your car

[Bogdan235]

My pin is not accepted at motor login ....

[Bogdan235]

Or it is a possibility to make a mistake when i try to find the ecu pin, what i should do to find that pin?

[rafal]

Or it is a possibility to make a mistake when i try to find the ecu pin, what i should do to find that pin?

read #4 .................

[Volker]

If you have original ecu:

- Read EEPROM from ECU and post file here
- With Login-Pin you can adapt VP44 to Immo with article in ross-tech wiki....
- Job is done


If you have donor ecu:

- Read EEPROM from both ECUs (original & donor) and post it here
- You can do ECU-Swap also with help from ross-tech-wiki
- If ECU-swap is done you can adapt VP44 (ross-tech-wiki and login-pin)
- Job is done


Or the hard-mode (IMMO off everything)

- Post EEPROM & Flash from donor ECU and post file here
- Write the IMMO Off files back
- Job done

[shadow12]

or there is a tool available to align immo with the push of a button, think this works with all psg and vp pumps fitted on 2.5 diesel engine, not sure of the make, bought mine on .bay

[Bogdan235]

I solved,
I was at AUDI and they didn't succed.
So i took my old pump ECU and added to the new one.

Thank you for help