Nissan Qashqai 2011 Dashboard Milage Calibration

[DeLuXe]

Hi!

I read the flash to my dashboard but could not load it into iProg software.
I read the file using VVDI Prog and in the program it tells me the flash (one of them) should be 256kb but I get the entire flash of 512kb.

Could someone please help me change the milage to 141010 km.

Thank you.

Best regards

[jomberykaso]

that mcu must be read in eeprom mode, not in flash mode, other important thing: put exact original mileage when you are asking for free help here, and press Thanks button when you recieve it

[catalinosonesti]

:congrats::congrats:good to know to say thank or pres button because is best help how can take by DK membres for free ,even how ask help no thank

[DeLuXe]

Hi again,

Ofcourse I will give thanks to the help given.
And If I possible have forgot in the past I am sorry for that, sometimes in stressful situations I forget and that is human.|

I read the flash in eeprom mode at first or in the file uploaded. It gave me 512kb in size when VVDI Prog Diagram shows me it should be 256kb.

Thanksful for all the help.

Best regards
DeLuXe

[jomberykaso]

your file is not good to be edited, you have to post a file in eeprom mode, not flash...here I post one of my files of Nissan Qashqai 2011 mcu Mc9s12xhz256,

your file must be as mine to be edited

[DeLuXe]

Hi again,

Alright thanks. I first read it in eeprom mode but I thought It was wrong because I only got 4kb. I saw yours was also 4kb so that must be it.
New file posted.

The car when eeprom was read had gone about 1534xx km.

Do I then program it as eeprom when sending it back to dashboard?

Best regards
DeLuXe

[jomberykaso]

Where is your new file....you waste my time mate

[DeLuXe]

Sorry mate. Forgot to upload it as well ofcourse.

Thanks for your patience.

[jomberykaso]

Now press Thanks Button located in the left lower part of each post