EDC16C35 BMW E91 320D 163HP

[naskochipa]

Hello friends i have a problem with one car per customer the car is a BMW e91 320D can anyone remove swirl flaps because the car has no power after mechanically removing them thanks

BMW E91
320D
163HP
EDC16C35
SW-389882

[teerak2uk]

Removed and blanked them or just remove?
Is motor still plugged in and any dtc

[naskochipa]

yes they are removed but the engine has no power there is no dtc
да, те са отстранени, но двигателят няма мощност няма dtc

[Baddog84]

swirl flaps off
pass pm
chks ok

[naskochipa]

swirl flaps off
pass pm
chks ok

Thanks but the car still doesn't have power
Thanks but the car still doesn't have power

[voltechcar]

what dtc have on stock file, just cut dtc + limp and should be back to live.

[teerak2uk]

Did you unplug swirl motor?

Did you fit these?https://uploads.tapatalk-cdn.com/20191230/3f54acb1a609d5119a3c889abe5b8278.jpg

[naskochipa]

what dtc have on stock file, just cut dtc + limp and should be back to live.

No mistakes, just the car accelerates very slowly

[naskochipa]

Did you unplug swirl motor?

Did you fit these?https://uploads.tapatalk-cdn.com/20191230/3f54acb1a609d5119a3c889abe5b8278.jpg


Yes plugs are stacked

[teerak2uk]

Swirl motor plugged in still or unplugged

[naskochipa]

Swirl motor plugged in still or unplugged

completely removed

[voltechcar]

One again...... what dtc have car? this is bakery or garage? First in car always is tool for diagnosis and dtc.

[teerak2uk]

completely removedSo must be DTC what you scan with

[naskochipa]

i read the car with launch x431 but it has no errors colt goes but very slowly

[voltechcar]

its not possible if car have disconnected flaps engine.

[naskochipa]

its not possible if car have disconnected flaps engine.


Ok if you say :) if there was a DTC I would have seen them the file of the car is not original the car does not record anything it goes but no powe

[voltechcar]

100% orginal software, dtc switch table is ok.

[naskochipa]

100% orginal software, dtc switch table is ok.

I know before you saw it also made me wonder why there is no dtc

[voltechcar]

if is ok this is easy job. Tool -> parameters -> 4-5 gear and look on boost , fuel, temp on sensors, differential pressure and you know because car not have power

[naskochipa]

if is ok this is easy job. Tool -> parameters -> 4-5 gear and look on boost , fuel, temp on sensors, differential pressure and you know because car not have power


The car came from Italy with this problem dff was very clogged so I removed it mechanically and software. I flooded egr removed and he software now and vortex valves, but the car still has no power done, but still did not have the necessary power to this day when I turned off the flowmeter and the car started to have a lot of power

[AVDigitale]

you have problem in maf sensor ,unplug maf and test,in bmw if maf is bad you don't have dtc but not power
test unplug maf first