View Full Version : SANDERO 2017
otojm
2nd January, 2020, 03:24 PM
Hi, i have to modify the odometer of this car:
Dacia sandero 2017 without abs
i connect Renolnk 1.79>>extra>>tbd for lgan2,sandero2,duster 2,logy(only forward wihout pach)
it read the km value correctly; and when i select "write km "it gives this message:
" 7F2E12 Sub Fonction Not Supported" & no chnges are made in the dash; (i try many trick with disconnecting batt);
without sucess!!
so any help is appreciated; Regards
jomberykaso
2nd January, 2020, 03:38 PM
where is your file if you need help to edit mileage?
otojm
2nd January, 2020, 04:49 PM
where is your file if you need help to edit mileage?
sorry this is the eeprom file read with Renolink !!!
and need 80000 km, regards
jomberykaso
2nd January, 2020, 04:51 PM
File no good
houdiag
2nd January, 2020, 05:09 PM
hi freind
I have the same ReNOLINk 1.79 cable. I fell in the same problem but not in the Sandero but rather the 2017 Logan. Even if it is supported by ABS system, the odometer value is stored in the electronic unit of a car. Therefore, it should be adjusted in the unit
jomberykaso
2nd January, 2020, 05:16 PM
read 9s12 dash and 95xxx abs, then post your files
otojm
2nd January, 2020, 06:30 PM
read 9s12 dash and 95xxx abs, then post your files
hi the car not have ABS ,and dash have Fujitsu mb96f6a6r same than logan2 ,(odo is on ecu valeo 42 also)..
and i have only Renolink to use for this car, so please i just need to know if someone is doing sucessuly those cars with renolink ? Regards
pktmagic
27th January, 2020, 10:37 AM
I also use renolink 1.87 to read clio iv ph2 flash and eeprom. Different size files than other tools i donīt have.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.