arejas
6th January, 2020, 03:52 PM
Hello,so i bought power supply for bench(on table) ecu programming and have strange problem.My power supply is 0-15V and up to 2A.It features
Automatically converts between Constant Voltage and Constant Current mode.
- The equipment have current limiting protection point free
- Single channel output
Ktag connected to external power supply and i can't regulate current for amps.
Voltage regulation is OK,working,but current is not. On Ktag idle,DC power supply reads 12.6V and 0.05A,while reading EDC16 voltage stays 12.6 and current goes up to 0.21A
and i can't make steady 1A or 1.5A.While reading i try change current with knob on power supply,but nothing changes.
Can someone help? Attached photos
Automatically converts between Constant Voltage and Constant Current mode.
- The equipment have current limiting protection point free
- Single channel output
Ktag connected to external power supply and i can't regulate current for amps.
Voltage regulation is OK,working,but current is not. On Ktag idle,DC power supply reads 12.6V and 0.05A,while reading EDC16 voltage stays 12.6 and current goes up to 0.21A
and i can't make steady 1A or 1.5A.While reading i try change current with knob on power supply,but nothing changes.
Can someone help? Attached photos