BCM dump Iveco daily - 95c230

[zeh212]

Hello all
i have an Iveco daily 2011 , tried with zed full via obd but nothing
so I taked out the BCM magnetti marelli with 95230 eeprom
i have make transponder by dump ID48 all was ok
but when I mount the bcm to the car , there is nothing
the car donÂ’t start and windows , high beam and every electrical option is working..

what at do you think ? Should I verify the soldering of the eeprom?
does someone have the pinout for the eeprom ?? Thx

[Staafonline]

Hello all
i have an Iveco daily 2011 , tried with zed full via obd but nothing
so I taked out the BCM magnetti marelli with 95230 eeprom
i have make transponder by dump ID48 all was ok
but when I mount the bcm to the car , there is nothing
the car donÂ’t start and windows , high beam and every electrical option is working..

what at do you think ? Should I verify the soldering of the eeprom?
does someone have the pinout for the eeprom ?? Thx

Do you have both dumps? did original key still work?

[Agilechaveiros]

check the weld, return the original dump file and see how the car behaves
which machine used the transpnder for general?

[TERMINATOR1000]

Hello all
i have an Iveco daily 2011 , tried with zed full via obd but nothing
so I taked out the BCM magnetti marelli with 95230 eeprom
i have make transponder by dump ID48 all was ok
but when I mount the bcm to the car , there is nothing
the car donÂ’t start and windows , high beam and every electrical option is working..

what at do you think ? Should I verify the soldering of the eeprom?
does someone have the pinout for the eeprom ?? Thx

Hello , you just kill the van !
1) IVECO DAILY with 95230 eeprom 2011 USE Transponder Philips Crypto 2 ID46 > PCF7936 > Original key with PCF7946
2) Always use OBD2 to program ( after read eep to obtain PIN code + pre-code data .
3 ) i hope you save original file ...