View Full Version : CAS3+ stuck in boot mode
PixelsFixed
11th January, 2020, 09:20 AM
Morning, this cas3+ eeprom is stuck in boot mode.
Can anyone tell me how to edit it in a hex editor to fix it please?
Chriz123
11th January, 2020, 09:27 AM
try and report pls
PixelsFixed
11th January, 2020, 09:41 AM
Thanks very much, but according to Cas3+ editor, it still shows in boot mode - haven't tried it on the car, though.
Chriz123
11th January, 2020, 09:59 AM
try on car
i dont trust an old cracked editor!
Chriz123
11th January, 2020, 11:37 AM
meanwhile tested on my bench
681174681175
PixelsFixed
11th January, 2020, 12:04 PM
Yes. Written to module and it looks good on the bench. Off to fit to car in a bit. Thanks very much. Are you willing to share the steps to fix it?
Chriz123
11th January, 2020, 12:20 PM
Used hextag dump tool
PixelsFixed
11th January, 2020, 12:28 PM
Great. Thanks. I'll let you know. Much appreciated.
PixelsFixed
11th January, 2020, 02:59 PM
No. Sorry. Not working in the car.
Chriz123
11th January, 2020, 03:12 PM
Does it crank ?
Does it have ignition?
What about DTCs?
More details mate
Or let’s start from beginning what did you tried to cause this problem ?
PixelsFixed
11th January, 2020, 03:32 PM
No. Sorry. Not working in the car.
droidwayne65
11th January, 2020, 06:46 PM
No. Sorry. Not working in the car.
Didn't have time to fully test it but boot mode is not quite as detrimental as programming mode. However, here are two versions. :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.