PDA

View Full Version : K Tag Clone can read Delphi ssanyoung DCM 3.2


carsandkeys
16th January, 2020, 02:14 PM
Hi all,

Im trying read this ecu Afor immoff. i need read only eeprom 95320, i open ecu but i cannot find eeprom in upper side, and botton side is strongly linked. Then i try read this via bdm with k-tag clone, but without success, i get error comunication, check feed and conections 0x100B. Im using protocol family 112 for ssanyoung and tata ecus.
23/5000















is strongly linked




23/5000
















is strongly linked




https://i.ibb.co/jf5RLpS/Whats-App-Image-2020-01-16-at-14-10-09.jpg (https://ibb.co/yPRS83r)
https://i.ibb.co/tHWc0nJ/Whats-App-Image-2020-01-16-at-14-10-10-1.jpg (https://ibb.co/j81GCqr)
https://i.ibb.co/PQJYbn9/Whats-App-Image-2020-01-16-at-14-10-10.jpg (https://ibb.co/5FC9zyn)
Myjector
16th January, 2020, 02:58 PM
Did you made an bridge?
carsandkeys
16th January, 2020, 05:05 PM
Did you made an bridge?
No. In my schematic dont see bridge. Where i must do this? Car is Ssanyoung Kyron D 2.0 DT 2007. Ecu A664 540 84 32 DELPHI DCM3.2AP
figani
16th January, 2020, 05:17 PM
you donīt need bridges...
did you solder adapter on pcb...?
carsandkeys
16th January, 2020, 05:34 PM
you donīt need bridges...
did you solder adapter on pcb...?

I solder the adapter holes in the pcb, then connect the 14AS00T04S. I try read with 14AM00T02M needle adapter too, with this show error message hardware not compatible, send log your distribuitor
carsandkeys
16th January, 2020, 08:25 PM
My fault. Eeprom in upper side. i try read this like 95320 and this give me error, eeprom is masked then i think that eeprom is in both side. later I try read the same IC like 95160 and read success.