BMW E90 not have ignition A0AA A103

[system]

hello

i have big problem

E90 318 105kw 2011

I cant switch ignition ON

when i try switch ignition, on dahboard show only airbag , and on central console only written , open and clouse driver door, inster key in ignition a try again.

i have second CAS, i try repair dump with bmw cas 3 editor, but no problem here. I try in new cas program only EEP, flash no. but nothing.

All fuses OK

i have on fuse box everywhere + 12. .. on CAS i have +12 on pin 34 and big one wire too.

im absolutly dont know what i can do it next

thanks for any help

[weld88]

I believe those faults are often related to an ELV problem. No steering wheel error sign on the cluster?

If they appeared suddenly, you should try to reset the ELV fault counter with your favorite BMW diagnostic software.

IBS sensor sometimes causes a no start, no crank situation. Dead battery recently ?

If this happened after adding a key by OBD port you may have the incorrect flash in your CAS module. What tools did you use?

Post your cas module info, eeprom and flash. Someone can verify that they match.


Cheers

[Manta1600]

I had 2 similar cars

https://www.digital-kaos.co.uk/forums/showthread.php/790834-BMW-E87-2005-Problem

First one E87 is still not runner

on the second one customer replaced IBS cable and all relays and fuses and car now is OK but I dont know what was the problem

on the bench key slot work and take the key - when connect to the car key slot is like dead

last time I forgot to try to put emulator on the steering lock - next time will try

[system]

thanks for reply

No, i dont have steering error sign.

I do reset and synch many times.Nothing..

Baterry is good, problem start after replace baterry. One day after (morning)


My CAS num . 61.35-9237047-01
2111363688

[system]

I believe those faults are often related to an ELV problem. No steering wheel error sign on the cluster?

If they appeared suddenly, you should try to reset the ELV fault counter with your favorite BMW diagnostic software.

IBS sensor sometimes causes a no start, no crank situation. Dead battery recently ?

If this happened after adding a key by OBD port you may have the incorrect flash in your CAS module. What tools did you use?

Post your cas module info, eeprom and flash. Someone can verify that they match.


Cheers




ii make bypass for IBS sensor but nothing

[weld88]

Your flash does not match what I have on file for that part #

Try this one.

[Chriz123]

A103 - Unplug all door handles, renew blown fuses clear dtc and check again
A0AA - install ELV emulator or use a ELV off Flash and check if ingition comes back

[BusCan]

A103 - Unplug all door handles, renew blown fuses clear dtc and check again
A0AA - install ELV emulator or use a ELV off Flash and check if ingition comes back

I confirm thank you very much