PDA

View Full Version : Hyundai Getz 2003 edc15c7 Pincode


carsandkeys
22nd January, 2020, 06:33 PM
I need pin code for this ecu. Here eeprom and flash file.
avital
22nd January, 2020, 06:53 PM
Pin : 95 08 80
In attachment file for emulator.
carsandkeys
22nd January, 2020, 07:02 PM
Pin : 95 08 80
In attachment file for emulator.
I must write this file in eeprom 5p08? the size is smaller that original
avital
22nd January, 2020, 07:09 PM
Not -> it is for emulator file ..... to add emu You have 2 way :

1- You can by add data from ECU to EMULATOR board 24C02 ,but in this option if ECU is LOCK mode not will start.

2- You can add EMU without modification eeprom on EMU board , only by diagnostic device and PIN ... in this option if ECU is in lock mode this procedure clear lock mode .
carsandkeys
22nd January, 2020, 07:58 PM
Not -> it is for emulator file ..... to add emu You have 2 way :

1- You can by add data from ECU to EMULATOR board 24C02 ,but in this option if ECU is LOCK mode not will start.

2- You can add EMU without modification eeprom on EMU board , only by diagnostic device and PIN ... in this option if ECU is in lock mode this procedure clear lock mode .

Lock mode you refer for ecu not virgin? with immo data?

I program this via diagnostic with the pin. I conect emu first red light, then yellow blinkind. Here with program done and green led on. i think that this is a good signal.

https://i.ibb.co/hLk5f5N/hyundai-emulator.jpg (https://ibb.co/6r2hBhS)
https://i.ibb.co/p3Z8dZs/hyundai-emulator-done.jpg (https://ibb.co/8j2p92R)

Thanks mate. i will test the ecu but seem that work like a champion!
avital
22nd January, 2020, 08:02 PM
the emulator checks everything by itself and has very clear status signaling - if set GREEN LED all is OK, dont remember in car cut line for org immo (smartra 2)
carsandkeys
22nd January, 2020, 08:09 PM
the emulator checks everything by itself and has very clear status signaling - if set GREEN LED all is OK, dont remember in car cut line for org immo (smartra 2)
I cut the output pin of the ecu where is solder the blue wire. with this must be enough. I will disconnect immobox before connect ecu, so that the immobilizer light does not come on, right?
avital
22nd January, 2020, 08:18 PM
double post
avital
22nd January, 2020, 08:24 PM
emulator work the same 100% as original immobilizer system -> the emulator do unlock ECU,immo lamp is manage by ECU thats so LED immo on dash work like in original not damage CAR.