nissan x-trail and kawasaki z750 correction

[spantor]

I need information on a 2006 Nissan X-Trail and Kawasaki Z-750 2006.
In both vehicles will it be enough to program only the dash to change mileage?
Could you pass me pinout and power pinout of both?
Thank you also if you have photos of epprom location.
Thank you very much in advance

http://imgfz.com/i/ZuxKdvY.jpeg

http://imgfz.com/i/hDqXSOp.jpeg

[Diagcar1]

Open the dashboards, read eep and post your files.

[spantor]

Pinout and power? I imagine just work on dash is fine. Right?

[jomberykaso]

Only dash is enough.

Nissan Xtrail 2006 has 93c66 x 16 bits
Kawasaki z750 2006 has 93c56 x 16 bits.

To power up both dashes go to power up thread, use "search in thread" function.

[agstur]

X-rtail...

[spantor]

thank firends! good work

[spantor]

I may do something wrong, but I can make sure that for example there are no satisfactory results when writing "kawasaki z750 power pinout" or kawasaki z750 power "
The majority of times I ask here is because I have not found good results in the search engine. so little for nissan x-trail

[spantor]

X-rtail...

I will need to install a 100k resistor between GND and the point described in the image, right?

[sebage]

In image is 100 ohm, not 100K ohm.

[spantor]

Maybe is 100 ohm.
What is the clk y + 5v pin in digiprog 3 clone? I have no problem identifying the rest of the pins by looking at the eeprom pins.

[jomberykaso]

You don't need to use the that

[Diagcar1]

Here connections


687151

[jomberykaso]

Here connections


687151

This is the correct one.