View Full Version : Renault edc16c36 failed on obd
Ignasvw
3rd February, 2020, 02:48 PM
Hi, i have renault trafic. After writing mod file with kess (Original) , car started to drop rail faults, engine is working roughly, rpm shaking. Coding was readed before, writed after few times, no success.
We written original file ,but same situation. I found bdm reading in this forum, written it over OBD but same situation, written same bdm reading on bdm with Ktag (original) , also same. Can someone see if eeprom corrupted?
1037388183
i attach ktag reading
figani
3rd February, 2020, 02:55 PM
... Coding was readed before, writed after few times, no success.
which year it is...?
you read/wrote by can bus...?
Ignasvw
3rd February, 2020, 02:56 PM
which year it is...?
you read/wrote by can bus...?
2008/Kline
Inquizit0r
3rd February, 2020, 03:43 PM
This is 2.5dCi. You must change type of FUEL PUMP in engine ecu coding. From TYPE 1 to TYPE2 (or from 2 to 1, i don't remember).
Make it with Renault Clip or LAUNCH.
This is all you need.
Babos
3rd February, 2020, 03:49 PM
Friend try adopted rail presure and regulator sensors!!!
immokill
3rd February, 2020, 06:50 PM
Yes you must do all adaptation you have in Renault Clip after that all will be ok . I had similiar situation. Just reading and writing will erase parameters.
Sent from my TELEFON
AVDigitale
3rd February, 2020, 09:17 PM
this ecu always to read and flash with CAN not Kline
and like others writted make all adaptation with Can Clip or Launch and all will be ok no worry
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.