PDA

View Full Version : Peugeot 207 immo


BraLaas
4th February, 2020, 12:37 PM
Good day

I have peugeot 207 year 2007
Anyone know if immo off is posible in this ecu
Ecu is IAW 6LPC.105
Any help would be much appreciated
Thank youhttps://uploads.tapatalk-cdn.com/20200204/1413b2a3f0dc564098d3b3ec96560223.jpg

Sent from my MAR-LX1M using Tapatalk
sergei5005
4th February, 2020, 01:39 PM
Hello friend. You can try virginice your file and recode with lexia. Try change all FF from line 4000 to 8000 in ST10F microcontroller for virginice . Save your original file before. Im test in 6LPB and work,but not tested in 6LPC.
BraLaas
4th February, 2020, 01:40 PM
Hello friend. You can try virginice your file and recode with lexia. Try change all FF from line 4000 to 8000 in ST10F microcontroller for virginice .Do you have pin points to read please

Sent from my MAR-LX1M using Tapatalk
BraLaas
4th February, 2020, 01:46 PM
Hello friend. You can try virginice your file and recode with lexia. Try change all FF from line 4000 to 8000 in ST10F microcontroller for virginice . Save your original file before. Im test in 6LPB and work,but not tested in 6LPC.Problem is no Communication with engine ecu and abs pump

Sent from my MAR-LX1M using Tapatalk
sergei5005
4th February, 2020, 02:08 PM
See this and compare with your board please !!!!
Follower92
4th February, 2020, 02:48 PM
You can only use emulator or virgin for me.

To make virgin, read flash and change all FF from line 4000 to 8000 in ST10F microcontroller as stated by sergei5005 and it has to work.

Pay attention when opening ECU, if you pull hard, cracks start from screw hole, this is a multi layer pcb, if you see cracks around screw hole, put it in the bin and look for a new one.

Attached also pinout. (Boot is inside ECU).

687718687726
sergei5005
4th February, 2020, 05:46 PM
Try read ABS module for find the problem or confirmed ABS module is good. Try read BSI and detect what module is silent. Veryfi all power sources ,grounds and wires can line good conections.
ammarben
5th February, 2020, 04:04 PM
connect can line from abs to ecu
BraLaas
5th February, 2020, 04:05 PM
connect can line from abs to ecuAbs also not connect

Sent from my MAR-LX1M using Tapatalk
sergei5005
5th February, 2020, 06:15 PM
check power sources and GND in ABS from BSM with wiring diagram,and check twisted wires (can bus) from ECU. Identify wires twisted colours. With multimeter verifi wires cut. Can you unplug ecu conectors and read with multimeter in twisted wires the impedance for find wires cut between ECU and ABS module. Same method between BSM and BSI.