PDA

View Full Version : Hyundai i30 2013y


barth71
3rd March, 2020, 07:20 PM
Hi
I read this dash with micro c66. I desolder from dash and read with adapter in upa-s. I use Upa-s plugin and read old mileage correct 268695km. I change with this plugin to 159209km but when i put dash back I have a mileage in Miles and the dash display a many light EPB, TPMS, the fuel gauge not work. Please help me check my dump and help me correct change this mileage to 159209km
Thanks for advance
Highboy
3rd March, 2020, 07:44 PM
You did not make a good read....Anyway there is a problem with your file uplaod too...................
jomberykaso
3rd March, 2020, 07:45 PM
your file is corrupted, maybe bad soldered
jomberykaso
3rd March, 2020, 07:46 PM
You did not make a good read....Anyway there is a problem with your file uplaod too...................

you are right, however you can open his file online:

https://hex-works.com/eng
barth71
3rd March, 2020, 08:26 PM
Unfortunately, it looks like it has damaged the dump :-)
I was sure the reading was ok because upa had the correct reading.
Can someone fix such a dump or can repair the damaged one? Board number 94003-a6190

And I have other read which I tried earlier after reading in upa. maybe this one is good
jomberykaso
3rd March, 2020, 08:35 PM
Post a picture of cluster.

Post a picture of label of cluster.

Post Vin number.
barth71
3rd March, 2020, 08:49 PM
I have a photo a dash but I dont have a vin because I have a car in my workshop and now I 'm in home
Diagcar1
3rd March, 2020, 08:51 PM
And I have other read which I tried earlier after reading in upa. maybe this one is good

No good read.
Diagcar1
3rd March, 2020, 08:57 PM
Here try this file, read and write 16bit
barth71
3rd March, 2020, 09:03 PM
Ok thank you very much . I'll try toomorow because Is to late to go a workshop. I report toomorow.
regards
barth71
4th March, 2020, 09:54 AM
unfortunately not work. Dash say " wrong coding". I try buy a another dash and try read once again with another programmer.
But if you have diffrent dump please upload. Thank you
jomberykaso
4th March, 2020, 03:14 PM
unfortunately not work. Dash say " wrong coding". I try buy a another dash and try read once again with another programmer.
But if you have diffrent dump please upload. Thank you

5 dumps to test, one of them should be work