Mazda 6 weird DPF light

[lucim12]

Hello to all
I have a mazda 6 2.0d 2008 with a strange problem. Dpf has been removed but dpf light still blinking after about 100 km or so, The error code was Barometric pressure sensor witch has ben replaced. But light dpf light still comes back without any error codes.


Could it be software issue or is this normal for mazda denso, if a sensor fails also dpf light iluminates?
i also attached software files

[flag]

is not normal, the dpf solution is not good, i can do good solution for you if you want

[flag]

post original file

[lucim12]

Both ori and dpf off file is in the archive above

[flag]

your box is full

[lucim12]

its clear now

[AVDigitale]

first you need to reset dpf soot before write dpf off mod
but if it bad mod then you get dpf light after 100km

[jurebv]

Best Regards

[mihaiti]

Also for mazda you should reset oil, injector corrections, dpf soot.

[lucim12]

mihaiti you are right, the dpf light did not clear until I reset the oil

[lucim12]

jurebv thanks but no pass for file?


the car is acting wierd at idle changes sound and fan runs for a sec ot two at times, if still returns returns dpf light will have to get new dpf off solution

[brmservice]

here you are. reset the dpf and oil