Swap dashboard of vw golf 5 2005

[Bianko16]

Hi guys due to a defect dashboard I need to replace it with another one but I have to programme it with che pin code.
I have tried to read the eeprom 24c32 but it doesn’t works, maybe the code is inside the mcu... can I read and write the pincode with a vag tacho cable or not? Have you other solution? Thanks


Inviato dal mio iPhone utilizzando Tapatalk

[cascais]

Super vag plus can read the code if im not mistaken

[gencho5]

You must swap immo data.

[Bianko16]

You must swap immo data.

Which tools can I use?
I tried to read the eeprom with upa,
I have also xprog and vcp


Inviato dal mio iPhone utilizzando Tapatalk

[genelsys]

super vag can read pin
car prog can do this
orange 5 is good
and fvdi

[Bianko16]

Otherwise can I do immo off from the ecu and it will works?


Inviato dal mio iPhone utilizzando Tapatalk

[Bianko16]

super vag can read pin
car prog can do this
orange 5 is good
and fvdi


super vag can read pin
car prog can do this
orange 5 is good
and fvdi
I tried with car prog with this diagram without success.... I have error “no communication” [emoji30]
https://uploads.tapatalk-cdn.com/20200309/acdddcf0abbebe486cd32f96a0537af4.jpg


Inviato dal mio iPhone utilizzando Tapatalk

[narkeleptk]

I tried with car prog with this diagram without success.... I have error “no communication”


Did you give 12V to it?

[Bianko16]

Did you give 12V to it?

Yes!


Inviato dal mio iPhone utilizzando Tapatalk

[volorucinski]

Hi guys due to a defect dashboard I need to replace it with another one but I have to programme it with che pin code.
I have tried to read the eeprom 24c32 but it doesn’t works, maybe the code is inside the mcu... can I read and write the pincode with a vag tacho cable or not? Have you other solution? Thanks


Inviato dal mio iPhone utilizzando Tapatalk

Stop what you're doing, a little. Diamantle the little board from the back side and reflow that big ic there. It's a common problem. You can use fvdi ok for clone it, super vag k+can 2.0 can extract the pincode and do the km and if uou have bothpincodes, use vcds to adapt on that car. Search on Ross-tech site the procedure for ipc adaptation.

[gencho5]

You must change dashboard only on diagnostic. ORIGINAL Audi, Smok and Vag tacho USB can make this 'swap immo data', for chinese clone I don't say nothing.