DL501 gearbox question

[Dietrich]

Hello mates

There is one situation that I can't understand.
I have AutoTunerTool master and I read file from the A7 3.0tfsi gearbox (virtual read).
File is 2mb. ECM titanium doesn't recognize it and I wrote to customer support.
They replied me that file is not correct and must be 1,45mb and AutoTuner file cannot be cut to use in ECM.
Also they gave me advice to use Alientech Kess for work :crushed:
Can someone check this file and tell is it's correct or not?

Thanks

[icezero2010]

Hello mates

There is one situation that I can't understand.
I have AutoTunerTool master and I read file from the A7 3.0tfsi gearbox (virtual read).
File is 2mb. ECM titanium doesn't recognize it and I wrote to customer support.
They replied me that file is not correct and must be 1,45mb and AutoTuner file cannot be cut to use in ECM.
Also they gave me advice to use Alientech Kess for work :crushed:
Can someone check this file and tell is it's correct or not?

Thanks

why u not simple cut the file from adress af5d0 is all empty

[jurebv]

Post numbers of tcu read , someone should have kess VR

[Dietrich]

problem is I do not have Kess to write it back :)

[jurebv]

You dont have to write it back, just use it in ecm

[lsdlsd88]

just forget about ecm and get someone to tune it properly.