View Full Version : bmw m5.2.1 m52 bosch ews
hguritr
19th March, 2020, 04:02 PM
i have a bmw e36 and i have put engine of e39 4.4 m5.2.1 ... the car is staring and works for 2 months ...sudetly the battery was died and car didnt start again because want ews-dme sync , but i can not make because ews it is not connected to k-bus ... i have attached ews file and dme file ... if someone can make the syncro file without making with inpa ... thank you
Lambda1
19th March, 2020, 06:16 PM
you need fullread for this operation
hguritr
20th March, 2020, 07:54 PM
you need fullread for this operation
ok i have make full read with tl866 adapter ... please let me know if is possibile make it ... thank you very much
kiszka
20th March, 2020, 08:15 PM
ok i have make full read with tl866 adapter ... please let me know if is possibile make it ... thank you very much
ecu isn is D123
ews isn is D123
Lambda1
21st March, 2020, 01:02 PM
As mate above told they are sync. you need to reset rolling code ...
hguritr
21st March, 2020, 09:11 PM
i have make reset rolling code with ews editor , i have check all unused , i have write to ews ... still the same problem ,,, car crank but dont start :(
jolidj
21st March, 2020, 09:13 PM
if you have launch you can try to synch with it
hguritr
22nd March, 2020, 04:57 PM
if you have launch you can try to synch with it
i dont have the way to connect ews with k-bus with ike , for this reason i want to make sync on the bench not in the car ...
hguritr
23rd March, 2020, 07:10 PM
THIS IS THE ERROR
kiszka
23rd March, 2020, 07:55 PM
THIS IS THE ERROR
show preview of actual data in EWS
hguritr
23rd March, 2020, 08:31 PM
show preview of actual data in EWS
i can NOT connect with ews ... becuase is another car with engine with ews3.3 ... i want a file dme + ews fully sync ...
hguritr
25th March, 2020, 01:52 PM
PROBLEM RESOLVED !!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.