VW Touran 2003 year change dashboard VDO Siemens - error on dash

[kobi2311]

Hi

I changed dashboard in Vw Touran from 2003 year. I needed to change it because the orginal was damaged. After I flashed Sec Block file from original dash to new (used) dash car started, but I have got "Error" message in place where should be the odometer value. When I turn off the ignition the odometer shows correct millage, but when I will turn on the ignition I have got still "error" message and when I will turn off the ignition I have correct millage again. And all the time like this. I used Smok X-Can. But with Carprog orginal and with X-tool same story.

VCSD in 17-Instruments shows this fault: 00003 Control Module 014 Defective

Orginal (old) dashboard is: VDO Siemens VWZ7Z0C7500866, V1312131, SW 0485, HWF02310, HWA02302, ID - 1T0920860A, 28.04.2003
New (used) dashboard is: VDO Siemens VWZ7Z0E2322884, V0003000, SW 1012, HW 003, ID - 1T0920862A, production date 16.06.2005

Is it problem with new (used) cluster? Is it damaged too? Or mayby is it problem with eeprom file? In attached original eeprom file read before write Sec Block file and eeprom file read one more time after write Sec Block file

[dana]

in attached u can find fixed one keep posted

[kobi2311]

but I have got "error" mesage on dashboard with both eeprom files

[kiszka]

but I have got "error" mesage on dashboard with both eeprom files
also give me sector block files
289792km is
test file eeprom
report me
https://mega.nz/#!5rgDUDDD
I think it should work ok

[kobi2311]

km value is: 289795

here is Sec Block file from orginal (damaged) dashboard which I flashed to new (used) dashboard

[kiszka]

km value is: 289795

here is Sec Block file from orginal (damaged) dashboard which I flashed to new (used) dashboard
sector block is ok

[kobi2311]

and I can see that fuel level sensor does not work too (still shows 0 fuel - with old-damaged cluster it worked good). VCDS shows fault: 00771 - Fuel level Sensor (G) 010 - Open or short to plus

[kobi2311]

so only the eeprom file is faulty? why it got messed? I did not tauched it - I flashed only Sec Block file.

What about fuel sensor level? Should it work too with your eeprom file?

[kiszka]

so only the eeprom file is faulty? why it got messed? I did not tauched it - I flashed only Sec Block file.

What about fuel sensor level? Should it work too with your eeprom file?
you made more kilometers

[kobi2311]

Yes. I did same value as in orginal (damaged) dashboard was. But "error" message appearsed after I flashed Sec Block file and before I adjusted km value to 289795

With your file fuel sensor level should work too?