2010 MERCEDES CLK350

[jvinhj240]

I have never done mercedes dash before. Basically I have old one that does not communication with any tools I have including VVDI, it can read EIS module .. I have another used one is there a way I can virgin the new one i got? or should I just transfer eprom chip from original dash. Any advice? Thank you .

[mercis]

w207? swap eeprom

[jvinhj240]

no need anything else?

[mercis]

if partsnumber same

[jvinhj240]

if partsnumber same

thank you, let me try that. can i use carprog read/write? or chip transfer chip?

[Freezzby]

Hi if exact part number you can swap eeprom if not make virgin dash and need coding back with xentry .

[jvinhj240]

i want to try Virgin, but I dont know how.
I also dont think these parts are identical. I am not sure, but they look exactly same.

[Freezzby]

Hi it's not same part number so you need to virgin , the first four lines replace with FF .

[jvinhj240]

Hi it's not same part number so you need to virgin , the first four lines replace with FF .

thank you. so i read eprom then next is replace first 4 lines with FF? i will post the dump, do you mind check? thank you

chip on board say 24LC128 BUT carprog doesnt' have so I read 24c128

i post dump original and make virgin do you mind check if i did it correctly?


thanks again

[jvinhj240]

i copy eprom everything works except SRS light is on. NO CODE in srs , do you think there is problem in cluster?



AIRBAG light customer say wasn't on before cluster problem.

[Freezzby]

Hi you have srs because not same part number .