W169 CHAGE EZS PROBLEM

[JFR-Tuning]

I have a W169 and change Elv and Ezs with org Avdi
that’s not the problem. Car start and run.
but dash I can read odo but show on dash only ———

i make Ezs & Elv virgin and prog dash >>> no success
I check vin >>>> both same and ok ( after I prog vin new in EZS }
i check odo in Ezs >>>>> 0 km ( think is the problem )
i prog with r270 line 410, 470 & 480 Manuel from a other post >>>> no success

have a m8 here to solve this problem ?

thnx in advance

[ilian_cho]

Read dash dump and post here with ezs dump.

[ilian_cho]

Or post SSID from ezs -read with avdi.

[JFR-Tuning]

Ok will do read Ssid from Ezs . Cash dump I don’t have here car far away

[ilian_cho]

you have 2 way. 1-0 km in dash and adapt with das. 2-to put ssid in dash dump - #29-#2C

[jolidj]

put 0 km on dash
and adapt dash with das ore avdi

[JFR-Tuning]

put 0 km on dash
and adapt dash with das ore avdi

thnx
but if I read odo in Ezs with das it show me 0 km . If I adap I become in dash also 0 km ( right) ? So after that I can chage odo to higher level?
notice that Ezs is s used one with more km before

[JFR-Tuning]

Solved for all

thnx for help i will edit this Post top learn for all

if y change Ezs dash show ——-
you Must make 0 km in Cash and Ezs
than Go with DAS. In Dash advance > Ansteuerungen > Gesamtliste aller Ansteuerungen
typ the Point
Ezs Immo data learn ( Inbetriebnahme, adapt Dass you Need online Connection )
result Must be : 1

now ist Show 0 km In Dash

take a avdi and make Right Kilometer in Dash an all ist fine

job done