Kess Clone V2 - reads but wont write

[alfamaniacs]

Hey guys,

I bought a kess clone of ebay v2 5.0 running on ksuite 2.47. I spent some time setting it up and have gotten the point where it will read via obd but not write
i set ecu up on the bench and it will read (and write sucessfully according to the program) but when i read the file after writing nothing has changed, still the same original file

Car is a corsa c 1.7dti 55kw with delco delphi hybrid DYRU ecu
Files i got off the internet

Any help appreciated

Warm regards

Andrew (South Africa)

[teerak2uk]

Maybe file from internet is same as original, post both files and id from kess

[alfamaniacs]

Thanks so much for your reply

707641707642

[alfamaniacs]

as i mentioned,

if I connect with OBD I can read succesfully but cant write - error in addressing the writing

if i connect on the bench, i can read and the write shows to be successful (including the logs) but the file stays the same (the software ID doesnt change)

[alfamaniacs]

here are the 2 files, the original and the stage 2

[Panathaole]

Hey guys,

I bought a kess clone of ebay v2 5.0 running on ksuite 2.47. I spent some time setting it up and have gotten the point where it will read via obd but not write
i set ecu up on the bench and it will read (and write sucessfully according to the program) but when i read the file after writing nothing has changed, still the same original file

Car is a corsa c 1.7dti 55kw with delco delphi hybrid DYRU ecu
Files i got off the internet

Any help appreciated

Warm regards

Andrew (South Africa)

To write by obd you must add external power to the battery (over 14v) when turn on the ignition wait few seconds, to close the preheating coil relay...

[carbon7319]

Your Original and "Stage 2" is same file.

[khaos87]

Hey mate, there's no so much can be done on that car, i've try to make you a some tune for your car, test and report.
Hit thanks and rep.
Pass in PM.

[JoeBB]

2.47 is bad sw

[volorucinski]

If you're using the same files, nothing will change. Obviously... If it only reads, but no writting, may be wrong software version you're using, or expired tokens.

[capkin92]

Hey guys,

I bought a kess clone of ebay v2 5.0 running on ksuite 2.47. I spent some time setting it up and have gotten the point where it will read via obd but not write
i set ecu up on the bench and it will read (and write sucessfully according to the program) but when i read the file after writing nothing has changed, still the same original file

Car is a corsa c 1.7dti 55kw with delco delphi hybrid DYRU ecu
Files i got off the internet

Any help appreciated

Warm regards

Andrew (South Africa)


you have to try more than one 10 try typing 15 times

[alfamaniacs]

........................................

[alfamaniacs]

........................................

[alfamaniacs]

Thanks for all your help - ill give it a try and report back :applause:

[bojannnn]

Did you resolve problem? Thanks!