View Full Version : W447 2015 dash
clauberty
28th May, 2020, 12:58 PM
Hello
read eep from dash on OBD
ori km is 355364
i wold need 165000
Thank you
Nicolas9
28th May, 2020, 03:53 PM
your file is not good..
remove dash. desolder eeprom.
read again, upload here.
clauberty
28th May, 2020, 04:32 PM
this is dash without eep, MCU 70F3525
Manuelgb
28th May, 2020, 04:41 PM
brother dismantle dash and take a 95640, upload file and I modify you
clauberty
28th May, 2020, 04:53 PM
brother dismantle dash and take a 95640, upload file and I modify you
this is without eep Dashboards VDO on MCU 70F3525
jomberykaso
28th May, 2020, 05:31 PM
Hello
read eep from dash on OBD
ori km is 355364
i wold need 165000
Thank you
Report...............
clauberty
28th May, 2020, 07:16 PM
attached are ori and after :applause: file
jomberykaso
28th May, 2020, 07:32 PM
attached are ori and after :applause: file
I don't think so. Original mileage is still present in your edited file. You can confirm what i'm talking about if you compare with my edition.
I think mileage is located in line 0C82 (65 3E 1E 02)
65 3E 1E 02 inverted is 02 1E 3E 65, if you convert this code to Decimal is 35536485, then the result is divided by 100, 35536485/100 = 355364,85 (355.364 kms)
jetronic30
28th May, 2020, 09:40 PM
what about can blocker?>
clauberty
28th May, 2020, 11:16 PM
what about can blocker?>
mounted in the dash
clauberty
28th May, 2020, 11:17 PM
I don't think so. Original mileage is still present in your edited file. You can confirm what i'm talking about if you compare with my edition.
I think mileage is located in line 0C82 (65 3E 1E 02)
65 3E 1E 02 inverted is 02 1E 3E 65, if you convert this code to Decimal is 35536485, then the result is divided by 100, 35536485/100 = 355364,85 (355.364 kms)
i will check this tomorrow
jetronic30
30th May, 2020, 09:13 AM
mounted in the dash
can you share can blocker connection ?
mikkhh
30th May, 2020, 11:28 AM
Cluster plug on cluster side has numbered pins.
PIN1 - GND
PIN4 - 12V
PIN12 - CAN L
PIN13 - CAN H
Use multimeter to find suitable points in dash.
jetronic30
30th May, 2020, 02:49 PM
Cluster plug on cluster side has numbered pins.
PIN1 - GND
PIN4 - 12V
PIN12 - CAN L
PIN13 - CAN H
Use multimeter to find suitable points in dash.
so just like in older Mercedes..
maucontacto
30th September, 2020, 06:09 PM
I don't think so. Original mileage is still present in your edited file. You can confirm what i'm talking about if you compare with my edition.
I think mileage is located in line 0C82 (65 3E 1E 02)
65 3E 1E 02 inverted is 02 1E 3E 65, if you convert this code to Decimal is 35536485, then the result is divided by 100, 35536485/100 = 355364,85 (355.364 kms)
After edit and install CAN filter it stays equal... no luck.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.