View Full Version : Nissan Tiida 2008 airbag
Alex789
13th January, 2010, 11:06 AM
Hi to all.
I have airbag of Nissan Tiida 2008 with crash.
p/n 98820EM10A (12V) M1
eeprom L56.
Does anybody know where to clear dump or, maybe, have dumps with crash for comparing?
melmar
13th January, 2010, 11:16 AM
Clear to try... please report results... thanks
Alex789
13th January, 2010, 11:21 AM
Clear to try... please report results... thanks
Thanks. I will inform result.
Alex789
15th January, 2010, 12:38 AM
Clear to try... please report results... thanks
Dump is OK. Thanks.
siwaski
17th June, 2010, 10:10 PM
I have the same sensor in my nissan tiida. I will try to fix it by your file.
melmar
17th June, 2010, 10:27 PM
Ok, hope you find it helpful..
welcome to the forum, as your new here, its good
to post a few works in the introduction section..
:proud:
adeltronic
13th December, 2011, 11:44 PM
Thanks, was in need this file!
magnacin
31st May, 2013, 06:45 PM
Thanks. I used your dump to verify a cleared one by myself but wasn't sure if I was ok. I cleared it ok.
cheero
26th July, 2014, 12:26 PM
tested and work OK !
DJairbag
5th April, 2017, 02:42 PM
Hello,
i have same problem i used your file, no failure on DTC but airbag Lamp not go off.
Can someone please help me!?
:( :(
dragon100
5th April, 2017, 02:50 PM
Post here your dump, somebody clear it for you ...
autocargo
27th December, 2019, 04:06 PM
Hello. I've tried few solutions myself for the same airbag module 98820EM10A. I have no failure on DTC but airbag Lamp does not go off... Haven't tried Carprog solution yet.... Maybe someone can tell me if it's good, I don't have vehicle to test... maybe somebody have tested solution... Thanks.
dragon100
28th December, 2019, 08:45 AM
Your cleared file ...
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.