Immo Dash Passat B5 Swap

[luki00769]

Hello i need swap immo from file Oryginal to NEW
I need Old Pin, Mileage in new File
Thanks

It is full read Via Smok
in 2 pack read via VVDi2

New Dash have different file structure .
It is HC11

[rafal]

desolder eeprom from dash and read in programmer

[luki00769]

It is old Magneti Marelli Dash

[kiszka]

It is old Magneti Marelli Dash
the size of the read eeprom is incorrect

[speedy100]

Hello i need swap immo from file Oryginal to NEW
Thanks

Hi,

Forget reading and programing. Just swap original EEPROM chip from old to new Dash.

Best Regards

[kiszka]

Hi,

Forget reading and programing. Just swap original EEPROM chip from old to new Dash.

Best Regards
what eeprom are you talking about
read the entire topic first
and then advise what to do

[speedy100]

what eeprom are you talking about
read the entire topic first
and then advise what to do

The TITLE is "
Immo Dash Passat B5 Swap "What is it that You do not understand???

[kiszka]

The TITLE is "
Immo Dash Passat B5 Swap "

What is it that You do not understand???

show me where this eeprom is located because I can't find him

[rafal]

yeah............
it is problem when user will not write correct data for as
if dash passat B5 before FL so inside is MCU HC11
anyway - in 1 post all data bad readed

[socha1997]

1. Use VagTacho5 and read a immo pin.
2. Do adaptation with vcds

Or
1. Read pin from ecu

Or
1. Read eeprom from ecu and do immo off

[speedy100]

Hi,
Even with MCU inside for people that have trouble reading it, most of the time because of clone programmer..., the solution is swapping the MCU... or loose the job...

Best Regards

[luki00769]

I send File from read vvdi2 in first post.