megane 2 steering df002 and df035

[carsolution]

Hi friends.
Have a Megane 2 from 2007 with problems in the steering ( DF002 and DF035 ).
Attached is the 24c16 dump.

Can someone correct the file to put this working 100%.
Thanks to all.
Best Regards,
Nuno

[baltazar3]

Hi friends.
Have a Megane 2 from 2007 with problems in the steering ( DF002 and DF035 ).
Attached is the 24c16 dump.

Can someone correct the file to put this working 100%.
Thanks to all.
Best Regards,
Nuno


Megane is NOT like Modus or CLIO...
Just swap with other ...no need coding.

[YannG]

I think swapping with an old unit is not a permanent solution. From what i gathered from the internet, the problem come with time when the solder on the board come lose due to constant expansion and contraction which in turn corrupt the eeprom. So a fresh dump is required and the FFFF is for the steering lock only and it doesn't apply to the OP issues

[aqua_life]

Already had a similar case that was solved soldering all mosfets solders inside ECU.
In my opinion you should try this. If not work, please try another eeprom file from forum and check error codes.

If I helped please press Thanks + Reputation.

[carsolution]

Thanks to all of you.
DF035 is Mosfets problems and its solved already but after a few km failed again.
Like Baltazar told, I swapped from another one and everything is working ok, just needed to write VIN and make the wheels and chassi configuration.
It seems to me that this steering is not like clio 3 and Modus, just swapp and do the configuration.
Thanks to all of you

[YannG]

Any picture available, that shows the mosfet that are prone to cracking?

[drz]

Megane 2 steering is plug&play, not need any coding/config. It works ok, different vin/config doesn't matter.

[bobasspr]

I have problem, with def002 on Modus. Could you fix the file? Thank You.
Modus 8200433517D 24c16 DF002

[carsolution]

Megane 2 steering is plug&play, not need any coding/config. It works ok, different vin/config doesn't matter.

Yes, it works ok without configuration, I just did it to stay everything ok like the original one (VIN and so on).
Thanks

[carsolution]

I have problem, with def002 on Modus. Could you fix the file? Thank You.
Modus 8200433517D 24c16 DF002

Hi friend, manually I dont know how to do it, I use Revolink cable.
Best Regards

[YannG]

Already had a similar case that was solved soldering all mosfets solders inside ECU.
In my opinion you should try this. If not work, please try another eeprom file from forum and check error codes.

If I helped please press Thanks + Reputation.

Hello, you only resolder the mosfets ? What about the eeprom dump ?