Need help Nissan Rogue 2013 URGENT

[MartinAGR1]

Need help to clear those DTC about pre-tensioner. I had 2 DTCs per side (right and left pre-tensioner) after install a resistor on both sides (2.2 ohms resistors) I clear DTCs and just have one code per side

I have these DTC's impossible to clear. Note: the pre-tensioner is in seat belt, doesnt have a second pre-tensioner in seat

B1177 PRE-TEN2 FRONT RH (OPEN)(Present & History)
B1182 PRE-TEN2 FRONT LH (OPEN)(Present & History)

I dont know if clear crash data doesnt work at 100% but I have uploaded If I need another resistor with other value please let me know
I have checked the pins of the srs unit and they are ok

Thanks in Advance

[autorebuilder]

That is a Nissan Rouge? You have 2 memory chips on the circuit board correct? 93C76 setting side by side?

[autorebuilder]

I looked it up and verified YES you do have 2 memories that need to be looked at. Read the left chip next to this one you read already and post that file dump.

[MartinAGR1]

Ill try right now one is RL76 Sop8 the other one is a short one side by side theres a 82C250 a can controller


I looked it up and verified YES you do have 2 memories that need to be looked at. Read the left chip next to this one you read already and post that file dump.

[yluis515]

tested solutions.




passs = rep+ thanks buttons

[MartinAGR1]

Ill try thank you

tested solutions.




passs = rep+ thanks buttons