Ranger 2009 8c

[BraLaas]

Good Day

Can someone please assist me with manual coding procedure for transponders.
I have pin code and 2 keys.
Would be much appreciated

Thank you

Sent from my MAR-LX1M using Tapatalk

[szengen]

Code Word Input Procedure
• A code word is composed of eight digits from 0 – 9. The manufacturer has programmed
it as unique figure into the immobilizer module.
• When you have entered the mode for inputting the code word with an unregistered key
according to the procedure described on the preceding page, wait for 5 minutes until the
security light flashes slowly (flashing frequency changes from 300 ms ON / 300 ms OFF
to 1.2 s ON / 1.2 s OFF).
• Input the code word according to the following procedure as shown in the example for
the code word digits “3” and “1”:
1. Turn ignition switch to the ON position while the security light is OFF and count three
illumination cycles. When the light is OFF after the third illumination, turn the key to
the LOCK position.
2. Wait at least one illumination cycle.
3. Then turn the ignition switch to the ON position (within 30 seconds) while the security
light is OFF and count one illumination cycle. While the light is OFF after the first
illumination, turn the key to the LOCK position.
4. Repeat step (2) for the remaining six digits.
5. When the code word is correctly registered in the PCM, the security light stops
flashing and illuminates. Carry on with the respective programming step.

1007_015
Inputting the code word “3” and “1”

1 Security light 6 On
2 On 7 Lock
3 Off 8 Ignition switch
4 One cycle or more A Code word “3”
5 Within 30 seconds B Code word “1”

NOTE: The number “0” in a code word requires 10 illumination cycles.
ey Replacement or Addition when the customer has only one or no valid key (code word is required)
1. NOTE: If no specific time interval is given, each step should be performed within 30 seconds of the previous
step.
2. Remove and insert key 1 five times at no more than 1-second intervals.
3. After the final key insertion, verify that the security light flashes. (300 ms ON—300 ms OFF)
4. Wait for 5 minutes until the security light flashes at 1.2-second intervals.
5. Input the code word. For additional information, refer to Code Word Input Procedure in this procedure.
6. After verifying that the security light has switched from flashing to straight illumination, turn the key to the ON
position.
7. After verifying that the security light goes off, turn the key to the LOCK position and remove from the steering
lock.
8. Insert key 2 into the steering lock and turn the key to the ON position.
9. Verify that the security light illuminates for 1—2 seconds.
10. After verifying that the security light goes off, turn the key to the LOCK position and remove from the steering
lock.
11. Insert key 3 into the steering lock and turn the key to the ON position.
12. Verify that the security light illuminates for 1—2 seconds.
13. After verifying that the security light goes off, turn the key to the LOCK position.
14. If there are 4—8 keys (valid and/or new keys), repeat Step 5 with each key.
15. Wait for 30 seconds.
16. After reprogramming, clear DTCs stored in the PCM.
RANGER KEY PROGRAMMING PROCEDURES
IMPORTANT : PLEASE ENSURE ALL PRECAUTIONS
ARE OBSERVED AS INDICATED AT THE FRONT OF
THE OPERATING MANUAL.
IN PARTICULAR : For vehicles fitted with STOP/START technology, the battery leads
must not be shorted together when the battery is disconnected as this can lead to damage to the car and
potential personal injury.
PRECAUTIONS