Programing key on Mondeo 2013

[alclot]

Hi mates,
I would like to program key on Mondeo 2013 but only I have body computer and key. Can I match key on bench?
I try tango and vvdi2 but they dont have support for this car.
Thanks a lot ;)

[rob h]

If they dont support it, then not.
Best way is with in and outcode, by obd.
So unless you have a bench setup.

[super jumbe]

Hi mates,
I would like to program key on Mondeo 2013 but only I have body computer and key. Can I match key on bench?
I try tango and vvdi2 but they dont have support for this car.
Thanks a lot ;)

Never saw ford module on VVDI2, is this AKL or just want to add key?

[alclot]

I would like add key on bench because I don’t have car

[super jumbe]

Smart keyless rolling key can not be done on table.

[lion0304]

Ford, Mazda better way is OBD.

[fred77]

OPEN BCM up and look for CAN transceiver - it'll be an 8 pin chip like stanard eeprom (soc8) . then connect its pin 7 CAN+ to OBD pin 6 and pin 6 CAN- to OBD pin 14.

Worth a try :)
for ref -
http://ww1.microchip.com/downloads/en/DeviceDoc/20005991B.pdf
https://components101.com/connectors/obd2

[paul_12345]

OPEN BCM up and look for CAN transceiver - it'll be an 8 pin chip like stanard eeprom (soc8) . then connect its pin 7 CAN+ to OBD pin 6 and pin 6 CAN- to OBD pin 14.

Worth a try :)
for ref -
http://ww1.microchip.com/downloads/en/DeviceDoc/20005991B.pdf
https://components101.com/connectors/obd2

And is the smart key receiver in the bsi?

[fred77]

And is the smart key receiver in the bsi?

Silly me. Yes
Seen them on ebay cheap.


Prob be easier to just put back in car