Airbag Pin Out

[cartagena]

Hello Every one, I need pin out for airbag module from ford taurus 2015 to read by UPA, can some one help me'
thank you

P/N: EG13-14B321-BA
MCU: XC2336A-56F

[chipfus]

Look here
https://carprotool.com/download/Pinouts/CarProTool%20Programmer/CPT%20JTAG%20XC2xxx/

[chipfus]

Look here
https://carprotool.com/download/Pinouts/CarProTool%20Programmer/CPT%20JTAG%20XC2xxx/


Then convert pins to upa

[cartagena]

Thank you,, very helpful

[cartagena]

hello m8 do you know what pin is missing for this RCM pin out? is this TRST?

[rafal]

P2: TDI
P3: TCK
P4: TRST
P5: GND
P6: TDO
P7: RESET
P8: TMS

some signals are similar:
(upa-s) GND= (x-prog) GND
(upa-s) RESET= (x-prog) RESET
(upa-s) TRST= (x-prog) TRST

(x-prog) RXD=TDI (upa-s)
(x-prog) TXD=TDO (upa-s)
----------------------------------------------------

CPT-1 UPA-7
CPT-2 UPA-9
CPT-5 UPA-3
CPT-6 UPA-2
CPT-7 UPA-8
CPT-8 UPA-6
CPT-9 UPA-5

[cartagena]

Thank you m8,, but in the picture above TDO and TMS color white do you know what is it?

[PSAcars]

Hello to all. You will have to connect upa like in picture. Pin P4 TRST from upa is not needed here. The short ( line in picture ) is giving power to trst pin of mcu. Connect other pins like in in picture and dont connect P4, read and post file.

[cartagena]

Hello M8 I got straggle when I followed the CPT connection in the picture and I got error reading by UPA. Now I make my own connection base in UPA and success reading in XC2361B-40F, can some one help me to erase crush data.?
Ford Ranger 2015
P/N- AB39-14B321-GB
Memory- XC2361B-40F

[swiderek]

can some one help me to erase crush data.?


This should work for you.

[cartagena]

Thank you M8,, all works,,,cheers

[fuzz1]

hello m8 do you know what pin is missing for this RCM pin out? is this TRST?

Hello

I would like to use usb-upa to read the chip

What do you do with the 12 v supply from the CPT pinout when using usb upa? should you supply external 12 v to the board?
thanks

[rafal]

Hello

I would like to use usb-upa to read the chip

What do you do with the 12 v supply from the CPT pinout when using usb upa? should you supply external 12 v to the board?
thanks

yes.............................

[fuzz1]

Thanks I'll try and see if i succeed.

[fuzz1]

Hi

Yes i can confirm reads with UPA just fine.

[jave735]

Hi

Can someone please tell me if I need to connect ground pin from the UPA to the module too? Or not advisable/necessary.

thanks

[danielif]

GND necessary!!!

[jave735]

Was wondering if needed cause was using an external power supply