Renualt megane ll 1.9 dci immo off

[andys1977]

Hi all , please could someone assist with a possiable immo off

Renualt megane ll 1.9 dci
Bosch 0 281 012 769

8200391966

eep: 95160

owner was driving car and switched off , wont start, someone else worked on original ecu, components missing from board.

Got a used ecu with same part numbers and swopped the 95160 eeprom from original board to used one.

when did a diagnostic scan fault code: DF038 computer eeprom fault.

car still not start.

any help much appreceaited.

kind regards

[nadhir]

hello teste this off and post result passe in pm
good luck

​button thanks

[andys1977]

okay thanks , will and report

do need to cut any wires or unplug anything

[Bllinda]

There must now be fewer mistakes. If you want to see ....

Press both buttons ( thanks + reputation )

[andys1977]

hello teste this off and post result passe in pmgood luck​button thanksAttached Files Attached FilesFile Type: rar Renualt megane ll orig ecu file_ImmoHi there, tried your file , no startthanks

[andys1977]

There must now be fewer mistakes. If you want to see ....Press both buttons ( thanks + reputation )thank you kindly, will try and report

[Bllinda]

Clear your PM

[andys1977]

Clear your PM

okay , done please resend, thanks

[andys1977]

There must now be fewer mistakes. If you want to see ....

Press both buttons ( thanks + reputation )


@ Bllinda, thanks for your file
write your file to ecu, car cranked 3 different trys to start
after that wont crank
did a diagmostic scan, only fault appearing is off rail pressure sensor open or short circuit.
checked pinout for sensor ,wirring is good, got 5v, earth and signal, diagnostic data show value of 250bar pressure,


no other key faults
sometimes when i try to crank , the starter just makes a click sound, thought maybe starter is faulty
put a test light on the wire to see if getting a starter signal , but nothing

any other ideas will be greatly appreceaited.

kind regards

[andys1977]

@ Bllinda, thanks for your file
write your file to ecu, car cranked 3 different trys to start
after that wont crank
did a diagmostic scan, only fault appearing is off rail pressure sensor open or short circuit.
checked pinout for sensor ,wirring is good, got 5v, earth and signal, diagnostic data show value of 250bar pressure,




no other key faults
sometimes when i try to crank , the starter just makes a click sound, thought maybe starter is faulty
put a test light on the wire to see if getting a starter signal , but nothing

any other ideas will be greatly appreceaited.

kind regards




Hi all, any other ideas to try

thanks kindly