1996 Mazda Bongo import key code ?

[Jimmy07]

Went to this car and I’m stumped

Picked door lock and decoded with MAZ24 pick give me 8 cuts

Instacode showing 7 cuts ?

MAZ24R showing 10 cuts so idea was pick lock get 8 cuts from door then fill gaps with instacode but...........

How many cuts are in this door & ignition?

What blank for this car ?

Being a Japanese import can codes be bought from a broker ?

Any advice on this would be appreciated 👍🏻

[rapidlocksmiths]

you picked and decoded 8 cuts so tells you its not 7 , did the key work in the door ? if yes then progress cuts using maz24r ? or have you tried this and failed to work ?

if your maz24r pick fit in the lock and if you felt and picked 8 wafers in the door then the door lock is not a 7 cut lock . if pick fits its likely correct section.

are you using the full 10 cut mazda pick , if so did you try picking and decoding the ignition ?

blank is maz20R , probably the 10 cut using ic card 44 , maz24r pick can decode these doors

[Jimmy07]

Thanks Rapid unfortunately don’t have the 10 cut pick I only have the 8 for door and boot.

I’ll order the 10 cut for ignition tomorrow along with some MAZ20R blades

Thank you for reply I know what direction to go this now 👍🏻

[keyprogramming]

Thanks Rapid unfortunately don’t have the 10 cut pick I only have the 8 for door and boot.

I’ll order the 10 cut for ignition tomorrow along with some MAZ20R blades

Thank you for reply I know what direction to go this now 
Key number is stamped on door barrel
743027
743028

[Jimmy07]

That’s maybe going to be the answer get a look at the door lock thanks mate

[the_big_d]

I have one of these vehicles, It's definitely a 10 cut, IC card 44.
I've never had to check out the barrels as I have an original key & the number is stamped on it.
So a MAZ24R lishi can pick and decode these?

[rapidlocksmiths]

if you have picked and decoded the door lock , then use instacode on maz24r to find missing 2 cuts or impression them , if running on different key then pick and decode ignition

[Jimmy07]

Thanks for replies I’ll try running it through instacode under card number 44 as MAZ20R

No joy the locks getting ripped out

[rapidlocksmiths]

when running options , assuming your decode is correct , remember that the sequence must be odd even or even odd , you wont get 2 even numbered or 2 odd numbered cuts next door to each other , this helps on worn locks where you may have a reading between 2 lines

[Jimmy07]

Great Rapid !

Blades arrived this afternoon do homework time lol