98820 3KA0A help needed

[Air]

Hello
after clearing I got no codes but airbag control light flashing

Pathfinder'14
98820 3KA0A
95128

Is it module issue or car side problem?

If I put orig crashed dump back I get frontal and side collision codes and solid airbag control light on cluster

All these 3 cleared dump getting the same - no codes but light is flashing

I've used Autel, Launch, Snap-on scanner

Please I need help

Thank you

[slick_dick]

when car first come was airbag light flashing?

because that is a sign of a dead driver if am not mistaken ....

[Gammoudi]

HERE THKS + REP FOR PASS

[Air]

I already did the Thanks + Rep

[Air]

HERE THKS + REP FOR PASS

I already did the Thanks + Rep

[badziewo]

Load your Carprog clear. Clear DTC codes in SRS system.
Go to Occupant Detection, Special Function and Zere Point Reset Function, Reset it . Done

[Air]

Load your Carprog clear. Clear DTC codes in SRS system.
Go to Occupant Detection, Special Function and Zere Point Reset Function, Reset it . Done

Thank you!
You just gave me the idea!

I didn't pay attention that I can't finish passenger seat calibration with my scanners, just thinking it isn't important because there are no DTC in SRS module

But after your post I narrowed it down and what I found is one seat scale sensor was broken physically

So after I changed this sensor the airbag light went off

Thank you