2020 suburu ascent 98221XCOOA R7F701O643 RH850

[glenchafe]

can anyone help with clear 2020 suburu ascent 98221XCOOA R7F7010643 RH850

[ElderDM]

Hi.
Test and report.
Regards.

[glenchafe]

Waiting to try this will post results

[glenchafe]

tried module now it has 33 history codes , run full system scan only codes are ones in airbag module and all of them are history, yet light is still on , try to erase and it says not possible because either engine is running or still has faults, yet all faults are history, even tried unplugging seat to see if it reads a code and i did get a current code , plugged back in and had nothing but history codes again and light still on. does anyone have a good known solution for this module? all help appreciated

[glenchafe]

here is what i am getting also tried another solution it ended up with 27 history codes

[Sanek222]

hi. here is your clear

[Sanek222]

750013
was cleared

[glenchafe]

will check tommorow and report back

[glenchafe]

sanek222 this cleared all those previous history codes out and left only this 1 code which doesnt exsist p0000 and its current not history

[glenchafe]

this is only code now if anyone can help thanks

[Sanek222]

try to reset this one by scaner

[Sanek222]

P0000 no fault codes in the system memory

[glenchafe]

tried to reset by scanner but says either engine running or fault code not fixed. all air bags that were gone are replaced and i cant find any meaning for this code

[Sanek222]

change the scanner. if you have launch then update it to 24 vers or upper

[ateyourv8]

Only way i could clear codes on this module was with SSM4. Had the same issues you do with launch, autel and snap on. All updated scanners.

[lwood]

this is only code now if anyone can help thanks
that means script clear too much. also there is still something wrong in vehicle. bad element. if you fix bad element . light will turn off with your current clear dump. the only bad thing. is how script clear too much. now scan tool does not display the right DTC..

[glenchafe]

i have latest update on autel im608 brand new tool just purchesd and wont clear , carpro tool does give me option to read and clear by connecting to pins but seems like when i connect it reads and clears but because its not connected to car it reads bunch of codes and hard writes them or so it seems