View Full Version : CAS+ MINI R56 bricked after Ista-P
Jexus86
21st September, 2020, 08:54 AM
Hi mates, i need help with this CAS+ from Mini R56.
Was bricked with Ista-P by passthru trying Programming, garage tryed update sw in all car and stopped in CAS. No communication with CAS, no ignition, no start after that.
I was looking in forum someones had same problem or similars.
Attached flash and eeprom dumps from CAS.
61.35-9217853-01 5WK4 9515ABR
HW:C4 SW:20.0 Cod:09 Index:06A0
Thanks in advance
Best Regards
pepi
21st September, 2020, 09:26 AM
Use this dump for repair eeprom data.
Jexus86
21st September, 2020, 09:59 AM
Hi mate, thanks for fast reply, i dont need program flash? only need program eeprom you attached?
pepi
21st September, 2020, 10:26 AM
Your eeprom is stuck on programming mode .
Jexus86
21st September, 2020, 10:34 AM
Ok, then i understand you my flash is ok, not needed program flash, only program eep you sendme which is in user mode, right?
I will do now, test in the car and report you, thank you so much mate
pepi
21st September, 2020, 10:38 AM
Programm only eeprom first , you must have access with the CAS , if you have problems with flash you can update it with winkfp.
Jexus86
21st September, 2020, 06:59 PM
Hi mate with your eep file i have same problem, not comunicacion with cas, no inginition...tested with somes diagnosis machines, inclouded inpa, then i cant update with winkfp
some other options?
thanks in advance
pepi
22nd September, 2020, 08:09 AM
Write this flash , your flash was damaged too.
Jexus86
22nd September, 2020, 12:03 PM
solved with help from other friend with bmw explorer i cant test your last flash file pepi car goes away from garage this morning, but thankyou so much for try help, really thank you
judor
31st December, 2020, 10:53 AM
Hi , need 9217853 0.pa sp daten file from ista .
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.