wowa557
30th September, 2020, 05:45 PM
Hello DK Members
I have a Problem with a Magneti Marelli ECU from Fiat Grande Punto 1,4l
IAW5SF3.M2 HW300 51798651
I have read the Flash with MPPS (K-Line Flash) MultiBOOT Boot Mode and after a have make it Virgin with UID 3.2.
I have also make Checksum with ultimo.
Problem is, i have written this file back and install this ecu to the car. Ignition on for 5 Minutes.
After i try to start the engine but nothing. I have try the same in the past but the same. Engine not start.
So what is the problem why the autocoding not work? What i have did wrong?
Could someone look at my file and if someone find the error pleas i want to now it.
Thank you very much at all.
I have a Problem with a Magneti Marelli ECU from Fiat Grande Punto 1,4l
IAW5SF3.M2 HW300 51798651
I have read the Flash with MPPS (K-Line Flash) MultiBOOT Boot Mode and after a have make it Virgin with UID 3.2.
I have also make Checksum with ultimo.
Problem is, i have written this file back and install this ecu to the car. Ignition on for 5 Minutes.
After i try to start the engine but nothing. I have try the same in the past but the same. Engine not start.
So what is the problem why the autocoding not work? What i have did wrong?
Could someone look at my file and if someone find the error pleas i want to now it.
Thank you very much at all.