View Full Version : Ktag MED17.5.21 read error
patrykv98
7th October, 2020, 11:13 AM
Hey! I have clone Ktag.
When I try to read this ecu i get error "Communication error with the ECU: control all connections; if the problem persists, send the LOG file to the assistance"...
All connections are good. I have tried many times and always the same error.
Does anyone have solution for this?
Gammoudi
7th October, 2020, 11:17 AM
CHECK ALIMENTATION TO THE ECU 12,.. V AND TO KTAG
bobolin4o
7th October, 2020, 11:17 AM
Yes, i have...
Buy genuine tool/tools and when this happened - "send the LOG file to the assistance"
patrykv98
7th October, 2020, 11:23 AM
CHECK ALIMENTATION TO THE ECU 12,.. V AND TO KTAG
I tried with an external power supply and the same problem...
patrykv98
7th October, 2020, 11:30 AM
Yes, i have...
Buy genuine tool/tools and when this happened - "send the LOG file to the assistance"
Everyone starts somehow...
You probably bought all the original tools and 4x4 dyno right away. And then you started learning chip tuning :witless:
bobolin4o
7th October, 2020, 11:55 AM
Everyone starts somehow...
You probably bought all the original tools and 4x4 dyno right away. And then you started learning chip tuning :witless:
Nope, but in one moment i realised, that i must have ori tools if i want to make "new cars"... this was before 5 years...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.