Can you check my stage 1 map

[vectrac20tsri]

Could anyone please check this file, please don't say it's bad with no explanation as to why


Torque and Drivers wish map have been set so I only have to calculate 1 map.


Maps changed


DRIVERS WISH
TORQUE LIMITER
SMOKE MAP
BOOST TARGET
BOOST LIMIT
SVBL
EGR
FIRST 3 DURATION MAPS
ALL SOI MAPS just by 1 degree in last Colum, Thought being EOI is close to stock.


Not sure if needed but set both IQ BY MAF and IQ BY MAP high not to limit anything

Ambient pressure from group 11 is 984 mbar which I used for calculating.

[familiozo]

Tq limiter all flat it is not good,but i like n75 deep idle mod.

[chrisimerk]

Tq limiter all flat it is not good,but i like n75 deep idle mod.

I was going to comment on that everything seems good except the TQ limit i wouldn't have it flat like that you want it be a nice torque curve if you follow the standard torque curve you be fine.

regards

[vectrac20tsri]

I have used the smoke map, although torque limiter is high it will never see these figures, I have calculated roughly 17.5 AFR at peak torque tailing off.

[vectrac20tsri]

It makes it easier concentrating on one map when calculating, not saying this is the correct way but it will default to smoke map as this has the lowest values.