Immo off renault megane siemens

[doutlaw]

I got an ecu to immo off. Been looking at fenix 5 procedures but looks like this ecu is different. Can someone please shad some light on how i can immo off ?

Few months ago i did a fenix 5 on car and wored wonders. Yet im sure this ecu has something different.https://uploads.tapatalk-cdn.com/20201016/0ae79a63ed56b90fd307d68e0b1870d4.jpghttps://uploads.tapatalk-cdn.com/20201016/17a5551842eb4c78b97c60b1c0abe50f.jpg

Sent from my Redmi Note 9S using Tapatalk

[rafal]

1 - find out on dk flash with clear clock of 28F512
2 - programm with clock
3 - switch ignition on for 15 sec
4 - swap flash with ori one
5 - cut pin 37
job done

[doutlaw]

1 - find out on dk flash with clear clock of 28F512
2 - programm with clock
3 - switch ignition on for 15 sec
4 - swap flash with ori one
5 - cut pin 37
job doneThanks rafal, your always the guy one could rely on.

The ic I have accessed is not 28F512 as it only have 7pins on each side. Guess i removed the sealer at the wrong location.

One the last ine i did, I remember shorting the pins on one side of the ic removed immo. Then i cut the immo wire from ecu. Pcb layout looks different on this one. And i wonder if that would work.

Sent from my Redmi Note 9S using Tapatalk

[rafal]

..............................

[martand]

not sure this is correct way to ask but i have a problem with megane 1.5 dci 2008. it has been stood for a couple of years and its caused a problem with the immo. the immo light stays on and car will turn over but wont start, i have tried to communicate with immo using launch equipment but i cant . i have been trying other ways using galetto 1260 but still no joy i cant find a driver listed in the galetto software for the siemens sid 301 ecu. is there another software i can use i have kwp 2000 and bdm also a vag com clone i just need to get it running to be able to sell it any help would be fantastic thanks