edge77
17th October, 2020, 06:07 PM
I own a 407 2.0 HDI with a Delphi 3.4 ECU, wich died completely after a jump start that was done.
i own Lexia, a Nexpeak K1 scanner, Galeto 1260, Galeto 4, Kess v2 being reworked, BDM 100, and also a PIASINI.
I bought a used ECU on eBay with same hardware number, wich is already recognized by Lexia and other scanners(original one wasnt, and fans were spinning)
Now, my issue is that i need to make it virgin, lexia says ecu already matched, and after some strugle, i was able to make a dump (1MB) with piasini soldering correct wires to ecu.
Whats the next procedure to make dump virgin and write it back to the ecu so i can match it after with Lexia?
Ps-Original ECU is dead, so i guess i cant clone it.
If someone can share some knowledge, i would apreciate.
Greetings from Portugal.
Thanks
i own Lexia, a Nexpeak K1 scanner, Galeto 1260, Galeto 4, Kess v2 being reworked, BDM 100, and also a PIASINI.
I bought a used ECU on eBay with same hardware number, wich is already recognized by Lexia and other scanners(original one wasnt, and fans were spinning)
Now, my issue is that i need to make it virgin, lexia says ecu already matched, and after some strugle, i was able to make a dump (1MB) with piasini soldering correct wires to ecu.
Whats the next procedure to make dump virgin and write it back to the ecu so i can match it after with Lexia?
Ps-Original ECU is dead, so i guess i cant clone it.
If someone can share some knowledge, i would apreciate.
Greetings from Portugal.
Thanks