PDA

View Full Version : VW Touran EDC16U1 which tool should be used?



user202
5th November, 2020, 06:55 PM
The car is Touran 2.0 PD AZV engine 136 LE with Bosch EDC16U1.

Which tool would like to use for read and write without problems. I always use battery charger during the read and write.

I know that Kess V2 some has a problem on OBD and could be fail during the writing.

Which one is better MPPS V18 China (best pcb 2019)
Or Galletto V54 Fw475 ?

I would like to do just EGR off and Hotstart whether it should let the tools correct the checksum during the writing.

Thank you very much. :)

dtip
5th November, 2020, 06:56 PM
Any would work, if you want to choose then galletto for vag edc16

Trice1001
5th November, 2020, 08:54 PM
kess clone do the job absolout fine and mpps too.

Trice1001
5th November, 2020, 09:08 PM
ktag witout oppening? can read on direkt connect?

Lambda1
5th November, 2020, 09:40 PM
yes service mode

mrjay88
5th November, 2020, 10:09 PM
mpps v18 is safe on this ecu i did a hot start and popcorn limiter on a family members golf mk5 with this ecu no problem at all

Neproify
6th November, 2020, 12:00 AM
Today i read and then wrote the software twice to the EDC16U1 in Golf MK5 using MPPS. I can recommend it. Reading took about 5 minutes, writing about 7. The only thing that I did was getting the battery charger connected just in case. :)

user202
6th November, 2020, 10:24 AM
Thank you for advices. It seems Mpps should work and Gallerto v54 also.
Does Mpps do full read of flash?
Do u usually use For EDC16U1 CAN or Kline ?
Battery charge is a basic eq which should be in use :D

dantetimoc
6th November, 2020, 11:02 AM
Thank you for advices. It seems Mpps should work and Gallerto v54 also.
Does Mpps do full read of flash?
Do u usually use For EDC16U1 CAN or Kline ?
Battery charge is a basic eq which should be in use :D
use mpps will be ok for this old ECU... all read by obd will be partial read only maps...
for full read use BDM - you will need to open ecu ori genuine ktag in bosch service mode withouth opening the ecu

user202
6th November, 2020, 11:09 AM
With Honda EDC16C7 it is full read by OBD 29f802 flash just I'm ask that maybe U1 has the same flash 29f802 and could be a full read, but I'm not sure about. :) Thanks

user202
8th November, 2020, 02:09 PM
I can confirm that with EDC16U1 the flash reading with Galletto V54 is full read of flash, and takes about 2 min. ;)
Write the flash took about 1.40 min. Everything is okay than.
Thanks the comments :) For sure V54 Galletto is a good tool on it.