04 MB 320CDI edc16c31

[MBS500]

hi


i have a 04 MB 320CDI.
with this ecu :


MERCEDES -Part number
A 648 150 01 79
A6481500179


Bosch -Part number
0 281 011 698
0281011698


i bought a identical used ecu that i want to clone with my car. is it possible ? some say it doesnt have eprom . only virtual eprom inside flash.
i have ktag . i vas hoping i could clone it with this , will it work ?
also when cloning i will have no immo issues ?

[Gammoudi]

YES YOU CAN CLONE THIS ONE READ FULL BDM AND WRITE TO DONOR ECU

[MBS500]

thanks.
but you sure it will be no immi issuses ? i heard also when opening this one i need to be very careful. because bdm pins is under ?

[Gammoudi]

NO PROBLEM I OPEN THIS TYPE OF ECUS EVERY DAY

[MBS500]

Okey any tips for opening then?

[Gammoudi]

VERY SIMPE OPEN CARREFULY WITH SCREWDRIVER

[MBS500]

okey. but i heard bottom part is glued to the circuitboard ?

[figani]

yes, glue...
heat it up....

or use new protocols, full reading without opening...

[MBS500]

Can you explain "or use new protocols, full reading without opening" ?

[Ivana31]

If you use ori ktag (also on clone able for some ecus) u have protocol to not open ecu. Its called Tricore Service MODE aka bench mode. Just need to pinout connector. If u have any problem contact me in pm.
regards

[MBS500]

Right. I have seen that under protocols. Will check it upt. Thanks for your help😁