MJD 6F3 fiat doblo immo off!!

[werewolf91]

hello to all pls have fiat doblo MJD 6F3.D4/HW04X need immo off psl
here attached flash and ep file

thanks

[vladanr]

772544 try this

[werewolf91]

this is solution from ecuvonix i try it and don't work

[vladanr]

ok not from ecuvonix ,from carsoftware

[werewolf91]

ob but it's same solution and i try it witout success :(

[vladanr]

772546 try this in epr

[Panathaole]

hello to all pls have fiat doblo MJD 6F3.D4/HW04X need immo off psl
here attached flash and ep file

thanks


mate immo off in this ecu is possible in flash.....

so post your flash here (2040kb)......

[werewolf91]

i poste it

[Panathaole]

i poste it


probably you don't understand, flash must be 2MB...... WHAT TOOL ARE YOU USING?

[werewolf91]

i read it bdm with ktag

[Panathaole]

i read it bdm with ktag


Then you have 3 files, eeprom 4kb mpc 512kb and flash 2048kb ......

[werewolf91]

no mate just have mpc and eep

[Panathaole]

no mate just have mpc and eep


read again... make full read and save separately..... what is the problem and you need immo off?

[werewolf91]

mate it's protocol P349 have just mpc and ep flash is not present

[vladanr]

did you desolder resistor 0ohm on flash

[werewolf91]

yes i did it

[Panathaole]

i just check, you have right, this unit is without ext flash.....

[Panathaole]

try this one, correct cks at writing.....

leave feedback.....

772611

[pipina]

hello to all pls have fiat doblo MJD 6F3.D4/HW04X need immo off psl
here attached flash and ep file

thanks

Hi, should work, as I use it many time and work OK.

Regards

[werewolf91]

so i try the 2 file car start juste one time after it don't start