sid206 ori bdm need

[jozoku1]

Hi.
Does anyone have an original bdm file from ecu sid206.
5ws40910b-t
at11-12a650-cc
Kess show ident
HW : CAFR1C10FR1C100
sw: 10180033AA
ford transit connect 2012 1.8tdci, 75 ps, p7pb engine.
First read with fgtech and after flash the car not work ok.
Lot of smoke and no communication ecu-esp.
ESP error occurs after engine starts. Engine work only on idle speed.
After that read ecu with kess.
Recalibration was also made with ids and no help.
Can enybody help.
Tnx.
BR

[ASCM]

Can you explain situation did you saved ori file first when you read with fg

Sent from my 5033F using Tapatalk

[jozoku1]

Read via obd by fgtech and kess. Not via BDM.
I have ori file read via OBD.
Tnx

[ASCM]

Read via obd by fgtech and kess. Not via BDM.
I have ori file read via OBD.
TnxIf you write ori file does the car work same as before you read ?

Sent from my 5033F using Tapatalk

[jozoku1]

No.
After write mod files (dpf off) car work normally about 5 min then turn off.
After restart car start normally but not work ok . And esp error occur.
After upload ori files no changes. Car not work ok.
Work very rough and lot of smoke. At full throttle small change. 1100 rpm

[ASCM]

When you make diag which fault you have with ori file

Sent from my 5033F using Tapatalk

[jozoku1]

p2263 - turbocharger boost system performance
no can communication esp-pcm U1900
Put blancking plate on egr - all the same.

[ASCM]

Did you recalibrated SW with IDS flashing

Sent from my 5033F using Tapatalk

[jozoku1]

Yes.
I wrote on first post.
All same. Now i want to dowgrade ecu to be sure.